Microgrids

Cat Power Grid Stabilization (PGS) Heavy Duty Mobile Module

Cat®Power Grid Stabilization-moduler (PGS) er skalerbare stabiliserings-moduler, der hurtigt kan implementeres i GRID-systemer. Heavy Duty udgaven af PGS-modulerne har en effekt på er 1.000-1.260 kW og er monteret på en sættevogn. Elektronikken i PGS-modulerne er med til at udjævne spændingen og frekvensen i et GRID-system og kan også bruges til at stabilisere strømmen ved opstart af gas-drevne generatorsæt. Når PGS-modulerne indsættes i GRID-systemer baseret på vedvarende energi, har de tilstrækkelig kapacitet til at levere backup-strøm i op til 30 minutter, når den vedvarende energikilde ikke er tilgængelig (fx når solen ikke skinner). Modulerne kan opsættes og forbindes parallelt med andre PGS-modulers såvel som med ETS- og ECE-moduler. PGS-moduler kan overvåges og styres med Caterpillars Microgrid Master Controllers. Til stationære opgaver anbefales Power Grid Stabilization (PGS) 20' modulet, der er indbygget i en 20 fods container.

Stabilisering Op til 1,2 x overload kapacitet

Kapacitet (kW) 1.000-1.260

Anvendelse Energi-stabilisering/-lagring

POWER GRID STABILIZATION (PGS) - MOBILE MODULE

Up To 1.2x Overload Capability

Up To 1/2 hr Continuous Power

Protects against power failure, voltage sags/surges and under/over frequency

Mobile Air-Ride Trailer with vibration-isolated battery banks and external service access

Specifikationer

Technical Summary

Application	Transient Assist
Module Type	Heavy Duty mobile Grid Stabilization
Rated Power	840-1260 kW

Power Grid Stabilization (PGS) mobile module

Download (PDF)

Fordele og funktioner

Reliable, scalable and mobile

Factory prepackaged and tested

Pre-engineered mobile containeron trailer with batteries, inverter, isolation transformer and other equipment installed.
Multiple energy storage systems may be paralleled up to 100+MW

Renewable integration

Designed to work with an array of renewable systems, including solar and wind
Seamless integration with Cat Microgrid Master Controller (MMC) allows for maximum renewable penetration and full asset control

Transient assist

When used with a generator set, the Cat PGS module will provide reserve power capacity to:

Decrease the transient voltage and frequency dips resulting from the application of large loads.
Enables highly-efficient lean-burn gas gensets to operate in island mode.

Grid stabilization

Protects against many typical power problems, including power failure, voltage sags/surges, and under/over frequency conditions.

High performance inverter

Built-in controls for the charging and discharging of the energy storage equipment.
Static VAR compensator.
Four-quadrant output power factor control.
Aautomatic anti-islanding to meet UL 1741 and synchronization back to grid.

Applicable standards and certifications

UL Listed to the following standards (certification and mark pending):

UL 9540
UL 1741 SB
CSA C22.2 No. 107.1/16
cULus mark

Declarations (pending):

CE Declaration of conformity
IEC60204-1

Cat Power Grid Stabilization (PGS) Heavy Duty Mobile Module

Specifikationer

Power Grid Stabilization (PGS) mobile module

Fordele og funktioner

Cat Power Grid Stabilization (PGS) Heavy Duty Mobile Module

Få et tilbud

Cat Power Grid Stabilization (PGS) Heavy Duty Mobile Module Microgrids